Vacuum Pump System: Air Pump Motor. Power Cable Length:1.2m(3 core cord ground plug).3Sucker(1.0mm/1.2mm/1.5mm). 3Neddle(0.7mm/0.9mm/1.2mm). 4Filter Spong(20.8mm1/16.8mm3). It is Recommended to take 3-5 times of Empty Suction to Full Clear the residual Tin in The Tube. If the interval is about 20 minutes, it is recommended to use a needle to clean the steel pipe after empty suction.
During the use, If the suction is reduced. Please use a needle to clean the steel pipe. If you do not use often, it is recommended to adjust the tin gun to about 200 degrees, and then adjust to the working temperature when using it. When the filter Spong is hardness, Pls replaced in time. The Reason For Block Desoldering Gun.
1The temperature is set too low for long time desoldering, The solder Tin does not reach the storage tube, But the temperature comes down. Sothey Stayed in the tube, Make it Block. The item "Electric Desoldering Gun Anti-static Desolder Pump For PCB Circuit Board Repair" is in sale since Tuesday, September 25, 2018. This item is in the category "Business & Industrial\CNC, Metalworking & Manufacturing\Welding & Soldering Equipment\Soldering/Desoldering Equipment & Accessories\Soldering Guns & Irons". The seller is "cnc-mall" and is located in Shenzhen.This item can be shipped worldwide.